Installation Guide – How to Install Seamless Wallpaper

INSTALLATION GUIDE – SEAMLESS WALL MURAL

Read this guide first. Prepare carefully, check the surface, and gather all tools before you begin.

Tools Needed:

• Sharp utility knife/ Box cutters

• Felt squeegee

• Protective floor covering

• Soft cloths for cleaning

• Adhesive tray & paste

• Wallpaper smoothing tool (non-abrasive)

• Wall primer

• Brush or roller for adhesive

Step 1: Wall Preparation

1. Check the measurements and the quality of the mural before installation.

2. Remove all wall plates such as sockets and switch covers.

3. Ensure the wall is smooth, clean, dry, and free of dust.

   • Sand any bumps.

   • Run a smoothing tool over the wall to detect imperfections.

4. Cover the floor thoroughly.

5. If the wall is porous, coat the entire surface with primer and allow it to dry.

6. Mix the adhesive well. Use vinyl/textile wallpaper adhesive.

7. Apply a generous and even layer of adhesive to the wall, including the edges.

Step 2: Installation

1. Work preferably with two people.

2. Unroll about 2 meters and check what is top and what is bottom. Have one person feed the roll while the other positions the top edge.

3. Unroll about 2 meters at a time for a good control of the wallpaper.

4. Use the 5 cm trimming margin to align the print correctly.

5. Seamless wallpaper is strong and can be repositioned gently if needed.

6. Smooth the installed section using a felt squeegee.

   • Glide from the center outward to push out air.

   • Apply moderate pressure but avoid using hard plastic tools that could mark the surface.

Step 3: Finish and cleaning

1. Hold a smoothing tool firmly against the excess edges and cut along it using a sharp utility knife.

2. Cut out openings for sockets and switches.

3. Wipe away adhesive residue immediately using a soft cloth with lukewarm water.

4. Dry the surface with a clean, lint-free cloth.